Download ntwind hstart7/11/2023 ![]() It simply shows as month 1, month 2, month 3, day 1, day 2, day 3 etc (with month 1 being one month ago, day 1 being one day ago - you get the idea). The data in the device is not date/time stamped. There is a catch here with the internal database and this is where HST in developing their plugin had a different opinion to me. You can delete the data, escapes me at the minute but should be in the manual for the Envi, it is a combination of button presses. ![]() Once every two hours this data downloads into the plugin and that is what I use to produce the charts. Thanks again, Marty.The Envi/EnviR has its own internal database, it keeps all sorts of data.84 months, 90 days and about 600 or some such hours (or thereabouts) worth of consumption data per sensor (not per channel). Is there a way to reset the data? I don't mind empty graphs as long as the data is genuine. Where has this data come from? I couldn't see any explanation in this thread. The funny thing the graphs seem to be populated with data for at least over a year. I have a relatively new HS3 clean install (including windows OS), Just over 2 weeks. I might just recreate the device as you suggest in case of future changes. Thanks for the advice on hiding as opposed deleting unused sensors. Not a problem if you do not ever foresee that happening though.another idea is just to mark them as hidden in the device views and they will not show but still be there in case you change in the future. One thing I will say is there are no problems deleting the unused ones but if you ever change that sensor to an optismart or a three channel sensor those devices will not be recreated (which might be a problem as the other previously used devices might be tracked in HSTouch or events which will need to be redone) and the whole set of sensors will need to be deleted and recreated (just deleting them and starting the plugin again will do it). Thanks again, Marty.Thanks for the feedback, much appreciated. So it was just a matter of deleting the unused devices (channels and pulse counters) to make it all look good. I see that all sensors are listed with 3 channels and a pulse counter by default. I have 2 appliance modules (sensor 1 and sensor 2) in addition to the base unit (sensor 0). Better than the default HS CurrentCost plugin. ![]() Just installed this plugin and it works very well. ![]()
0 Comments
Leave a Reply. |